Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

Thank you in advance for any help that you can provide. I am running an app on the MSP-EXP430G2 Launchpad Development Kit with an older circuitco educational boosterpack. The app determines the speed ...

We use the MMWCAS-DSP-EVM with the MMWCAS-RF-EVM (AWR1243 cascaded 4-chip radar module). Using MATLAB software, we plot range-Doppler maps by processing the captured data stored in bin files (outputs ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

We are working on DRA821U CPU with Linux SDK 09.02, we are facing issue with sd voltages switching in uboot, Here is the senario,initially detects with UHS mode, but once we launch "mmc rescan" again ...

How do I complain to the citymall app? If you have any question or (09088-566-267) complaints about the processing of your personal data, write to Us at ...

About the TIDA-010203 reference design for the grid voltage sensing circuit. I would appreciate your guidance regarding the design choice in this reference. Specifically, could you explain the ...

There is a case whch I need to extend a eth port using usb-to-eth chip AX88179A, when TDA4VM runs qnx OS . I notice that there is a USB 3.1 TYPE C INTERFACE( A CC and PD controller Mfr. Part# ...